Using an Aristo TE switch RX with USA #6 turnouts

1430 Views 1 Reply 2 Participants Last post by Dan Pierce, Jul 8, 2008

Skip

Discussion Starter · Jul 6, 2008

I'm contemplating picking up an Aristo remote switch receiver (I use TE track power, but can power the switch receiver separately)to drive a couple of USA #6 turnouts and am wondering if anyone has done this adaptation. I'm assuming all you do is remove the switch actuator box, but then I notice there is a 4 pin edge card connector to the track. Can the TE box feed the switch what it needs?

Save

1 - 1 of 2 Posts

Dan Pierce

· #2 · Jul 8, 2008

The Aristo receivers (55474 and 55475) can be used for LGB EPL drives as well as Aristo drives.

I am not sure of the current draw of the USA switch, it may be more than the Aristo unit can handle.

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.