G Scale Model Train Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
49 Posts
A nice trick with these pins or nails is to use a pair of pliers that have a slight "gap" at the bottom of the jaws near the pivot point. Ever so slightly squeezing the pin will flatten two sides, rotate 90 degrees, squeeze again, and you now have a square head bolt. By all means, ALWAYS have fun!
George
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top