G Scale Model Train Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
2,062 Posts
Discussion Starter · #1 · (Edited)
While participating on a project had to made adjustments on the boost and limiter boards. All the light and squinting didn't help me find the slot in the screw. A little touch of White Out on each, and DO DA.
Automotive tire Asphalt Electrical wiring Bumper Gas
 

·
Registered
Joined
·
3,527 Posts
The screws that hold the AristoCraft track together are much worse. They are really tiny and made of stainless steel so a magnet will not attract them. You have to put grease on the Phillips to make them stay. Then if they fall in the ballast...., "bye bye."
 

·
Registered
Joined
·
3,527 Posts
Have both. The hex heads are easier to deal with, and more obtrusive. I don't usually bother with the grease on those.
 

·
Super Modulator
Joined
·
21,409 Posts
there were a couple of years where the hex recess was very shallow, they would not stay on the wrench... swapped a bunch out... then I found split jaw clamps and never looked back.
 
1 - 5 of 5 Posts
Top