G Scale Model Train Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
42 Posts
Try tugging it at different angles. On the interior of the dome is a metal ring that clips into a groove on the water cap. The clip on my engine is also a little tight, and removing the dome required a lot of cajoling the first few times. Replacing it with another dome should be quite easy, just make sure it fits over the cap.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top