G Scale Model Train Forum banner
1 - 1 of 1 Posts

· Premium Member
1,064 Posts
I take a small screwdriver to remove the screws/wax. The screws are placed on a piece of cardboard. A hair dryer or heat gun then melts off the wax, which is absorbed by the cardboard.
If there is a small bit of residual wax in the hex socket, it will help keep the screw on the driver.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.