G Scale Model Train Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
58 Posts
Discussion Starter #1
I have an LGB Mikado which has an increadibly noisy gear train. I have tried grease, oil to reduce the grind but to no lasting effect.

I think I need to replace the gear component tems 100, 102 and 118 from the attached diagram to see if that soves the problem

http://www.gartenbahn.at/g_spur/downloads/downloadarchiv/lgb/eplosionsz/20872P-1.PDF

The question I have is where might I get the spare parts from? No luck with LGBoA - can any one suggest a source of these spares OR any alternative solution

Regards

PHIL
 
G

·
Guest
Joined
·
0 Posts
Phil,
Try Watts tains, they have some parts they'd be your best bet..
Nick...
 

·
Premium Member
Joined
·
1,976 Posts
Phil,

Did you check to see if the one of the wheels slipped a tooth? The way this engine is driven, the motor drives the #4 driver and the #1 driver through a long extension. The two intermediate drivers are along for the ride and typically take up the slack. I know when I removed the botom plate off my LGB Mike, it would have been really easy to move one of the drivers.

When you look at the gears, are they worn down? Do you have a star drive or the knuckle drive? The Star drive was a problem, and mine ended up destroying itself in the middle of an open house. I was able to send it to LGBoA who replaced it with a knuckle drive. Now, I don't run her with heavy trains or as frequently.

Mark
 

·
Premium Member
Joined
·
173 Posts
Phil-

Try emailing LGB in Germany.

LGB Reparatur Service
Witschelstraße 104
D-90431 Nürnberg
Telefon 0911/83707-38 or -43
Telefax 0911/83707-70

Email:
Rene.Leikamm at lgb.de
(Replace the "at" with an @ symbol)

Good luck!

Best regards,
Bob
 

·
Premium Member
Joined
·
58 Posts
Discussion Starter #5
Thanks for the answers. i think I have the star gear chain - i will check to ensure that i have not missed a tooth and will try and get in touch with LGB europe

thanks

PHIL
 
1 - 5 of 5 Posts
Top