G Scale Model Train Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
4,484 Posts
Discussion Starter · #1 ·
Got my Mike back the other day from Aristo's rebuild. 70's here today, so I fired it up and had two good runs with the it today, after replacing the Tx battery, worked fine inside, but then not when I got it up to steam. warm day, still had to squirt some steam in the water bath. Did not hook up the whistle , but did try it out and it sounded pretty good. Safety was blowing at 45, so may increase it just a tad. So now I can get the servo in and give that a try. Sorta moved the water bath valve around a bit, so should be a easier install.

I still need to change out the stock chuff pipe, not sure which I will go with. Still have my original cut off one and Charles' blast nozzle. May start with that, with my 'chuff enhancer' thing I made from a .45 cal shell, have not really tried it on it running outside. I did put on the brass sleeve over the end of the burner, flame sucked right back inside, with a feathering of the gas valve.

Weather is going back down, so glad I had a chance to try it out. Was a bit nervous, had been awhile. Here's a couple of pix. may post a short video later, FAB day!

They stuck on a D&RG plastic top pieces, I did put my 444 cab back on, did not send the tender in.
 

·
Premium Member
Joined
·
5,633 Posts
Do you still have the gas regulator in the tender. If so may want to take out and solve another problem. 70 degrees and it still should have run without a gas problem. Later RJD
 

·
Premium Member
Joined
·
4,484 Posts
Discussion Starter · #4 ·
Charles, they put on a whole new top, just used my wheels/cylinder/frame, I guess.
RJ-I bypassed the fuel regulator years ago. Was losing pressure, fuel tank was cold, squirted in some steam, pressure came back up. I was using 70/30 fuel also. Had to do it some at Marty's last year and you know how warm it was there then.
 
1 - 4 of 4 Posts
Top