G Scale Model Train Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
4,265 Posts
When using brass for lights, the brass can be one of the wire leads, just feed a single wire to the center of a bulb and solder the outside of the bulb/socket to the hollow brass rod.
This allows for much smaller tubes to be used and if you use transformer enamel wire, it can be very small.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top