G Scale Model Train Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm looking for someone who has a small lathe and would be interested in turning down some NWSL flywheels to a smaller dia. They're going to be installed inside NWSL largescale 4 wheel power trucks. I'll press them on etc, but I don't have the capibility to turn them down in dia and length. I'm paying for this service, so if you know of someone, please contact me, either here or offline at [email protected] Thanks for your help. XL_SPECIAL, MILW Road Train 261.
 

·
Vendor
Joined
·
3,324 Posts
Hey.... 261..... Try this email address. His name is Anthony's and he does work like this for O and HO for NW Shortline stuff and can sure help you.

Tell him I sent you and he'll charge you double... NOT!!!!




[email protected]
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top