G Scale Model Train Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
133 Posts
It could also be the board. I've seen a few that were behaving exactly as you describe and the issue ended up being the board. Rule out the connector as they mentioned above (you can cut 1/4" off the connector and re-seat the pins on the fresh bit of wire - the wire tends to break internally from being pulled on so many times). Once you rule out the connector, the next most likely culprits are either the chuff sensor or the board.
 
1 - 1 of 1 Posts
Top