G Scale Model Train Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
Hello fellows,



Just curious if anyone happens to have one of these buggers (seems to be marketed under half a million brands):







I'm still on the hunt for some proper diameter drivers for one of my scratchbuilds, and I think this just might fit the bill, though I'm not particularly keen on plopping down near $100 for something that might not work out.



That said, would anyone here happen to have one here? If so, might I trouble them to measure the drivers, both at the flange and railhead contact point? Would certainly make my life a bit easier :D



Take care,



-Kurt
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #4 ·
Interesting - this would put the Buddy's driver diameter roughly the same as - if not slightly larger then - the Bachmann Big Hauler.

I've since ordered a parts Big Hauler in the meantime, but if worse comes to worse, I might go for one of these little buggers.

-Kurt
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top