G Scale Model Train Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
I finally decided to give one a try. I used 1/2 x1/2 square tube, 16 gauge. The bridge was stick welded and then I soldered all the joints to give it a smooth apperance. It is about 6' long and 14.5" tall. 
 

·
Registered
Joined
·
53 Posts
Discussion Starter · #11 ·
I have a six foot by 6" piece of c- channel as a bridge now. I was going to set that inside the bridge. That is why there was no stringers welded in. I probably should have said that along with the post.
 

·
Registered
Joined
·
53 Posts
Discussion Starter · #21 ·
I probably will just run two stringers or there is a guy in our club that said he would make me a nice wood deck for it. I would like to use the GMM handrails, but I am cheap and would rather just make something.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top