G Scale Model Train Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
112 Posts
Discussion Starter · #1 ·
I have found a replacement water gauge for the Aristo Mikado. The original is a bit oversized 7mm X 1 threaded gauge.

Reeves in the UK makes an 8mm threaded gauge but they advised against drilling and tapping to that size with the original bushing.

The replacement I found from Coles Power Models is available in 1/4" and 5/16" sizes. At .312 I am hopeful there is sufficient material around the fitting to make it safe to D&T to that size.

Are there any specs or recommendations as to the amount of bushing material surrounding the fitting?


Thanks

Andre'
 

·
Premium Member
Joined
·
112 Posts
Discussion Starter · #3 ·
I am not just replacing the glass. This is a complete water gauge replacement as the original was damaged beyond repair or salvage.

Andre'
 
1 - 3 of 3 Posts
Top