G Scale Model Train Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
Quick question (for the James project) - might anyone have the driver diameter (that would be including the flange) of the LGB Mogul and Aristo Rodgers?

Seeing that James is a close-coupled machine, I don't wish to take any chances this time. The powerblock chart here on this site specifies the diameters of both wheels minus the flanges - sufficient for me to narrow down the wheel selection between these two units, but not enough to find out whether the LGB flanges will be too large to fit under the splashers.

-Kurt
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #4 ·
Thank you, Andrew.

This does help, though I could still use the exact diameter if anyone happens to have it. 2" is just about the max I can work with on that machine - every millimeter counts - and I'm not looking to buy another set of drivers that don't fit ;)

-Kurt
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top