G Scale Model Train Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,643 Posts
The sensor board slides out.
Going to flog it even though it's dead, huh?
You may need to remove the boiler to access the wires to push them out and pull them in.
The front wall of the cylinder assembly comes off, but if I recall, you have to remove the front frame piece to get it off.

I clean them up by removing all that extraneous crXp anyway, so they've all come apart that far.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top