G Scale Model Train Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
15 Posts
Discussion Starter · #1 ·
Does anyone happen to know what thread Accucraft uses in the backheads of its boilers? I'm talking about the one that is center above the flu -- came with a clank valve on the mogul, and plugged on the 4-4-0.

Is the threaded plug at the top of the water glass banjo on the 4-4-0 the same thread?

[FYI, I'm trying to figure out how to use that pre-existing hole both as a water feed and a steam pre-heat tap. Maybe not practical to do both though.]

Thanks,
Joe
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top