ShadsTrains
Moderator
West Jordan, UT
Conductor
Posts:578
Send Message
 | | 06/10/2008 12:46 AM |
| | Just for curiosity's sake, what's the minimum curve that a bachmann 0-4-0 can take.. Could it take a 16-17 inch diameter curve? What about the little diesel loco? | |
Shad Pulley
Webmaster
www.mylargescale.com
As Abe Lincoln once said: "You can please some of the people all of the time, you can please all of the people some of the time, but you can't please all of the people all of the time." | |
|
Dwight Ennis
Moderator
Milpitas, CA
Engineer
Posts:1493
Send Message
| |
vsmith
1st Class Member
SoCal
Engineer
Posts:1032
Send Message
| |
ShadsTrains
Moderator
West Jordan, UT
Conductor
Posts:578
Send Message
| | 06/10/2008 10:34 AM |
| | Sweet.. Thanks.. Just what I needed Dwight.. Rolling stock curves too.. | |
Shad Pulley
Webmaster
www.mylargescale.com
As Abe Lincoln once said: "You can please some of the people all of the time, you can please all of the people some of the time, but you can't please all of the people all of the time." | |
|
Dwight Ennis
Moderator
Milpitas, CA
Engineer
Posts:1493
Send Message
| | 06/10/2008 11:15 AM |
| Someone posted that a while back and I saved it. " border=0> Useful info to be sure!
BTW, Backwoods Miniatures has a neat conversions for the B'mann dismal, as well as On30 canter-cab conversions for Athearn and Roundhouse HO mechanisms. Check 'em out. A few are near the bottom of the page, so scroll all the way down. | |
Dwight Ennis
Milpitas, CA
SA #21
http://www.SantaCruzLumberCo.com
 | |
|
ShadsTrains
Moderator
West Jordan, UT
Conductor
Posts:578
Send Message
| | 06/10/2008 1:03 PM |
| Thanks for the video Vic.. Definitely sharper than what I'm looking to do. I'm digesting this and formulating ideas in my head.. Look at this video.. it's a lot in a little space..
Too much almost.. But cool with very sharp curves.. | |
Shad Pulley
Webmaster
www.mylargescale.com
As Abe Lincoln once said: "You can please some of the people all of the time, you can please all of the people some of the time, but you can't please all of the people all of the time." | |
|
Allan W. Miller
1st Class Member
Struthers, Ohio
Brakeman
Posts:84
Send Message
| | 06/22/2008 3:32 PM |
| | I know the Porter and Davenport will handle a 13-inch diameter curve. I'm building an On30 pizza box layout myself at the present time, and I'm running an article on one built by another fellow in the Oct. issue of the magazine (O Gauge Railroading magazine) which will be featuring On30 narrow gauge via several different layouts and an interview with the folks at Bachmann. The Oct. issue will be released early in Sept. | |
Allan | |
|