| Author | Messages | |
lqdsky
Posts:0
Send Message
 | | 08/01/2008 9:42 PM |
| Hi,
I currently collect 2 scales. N & Large 1:20.3. For my n scale layout I have switched over to DCC this last year and loving it. I would like to switch my large scale layout over.. I currently have a Digitrax Zephyr with a DT400R throttle.
For my large scale set up, I have a temporary layout using Aristo Steel. I'm currently purchasing Sunset Valley for my perminant layout.
My Engines include all Bachmann:
K-27 w/ QSI aristo sound decoder & programmer software
Consolidation w/ Soundtraxx Sierra
Side Tank Porter
Shay
My questions.
Will I only need a Digitrax DB200+ 8amp Booster to get started on running 2 engines at a time?
I'm sure I will need a DCC meter to determine how many amps each decoder would use. Would you recomemnd one like Tony's DCC reader? Is there a cheaper option?
Since my K-27 is the only engine with a mobile/sound decoder, I will need to purchase decoders for the rest of my engines. I will have to read up if the Sierra has a mobile decoder.
Since I have the QSI programmer, I should stick with using a QSI magnum with my Shay. Is there any known problems with installing that sound decoder with the Shay?
Also any recommendations for a mobile only decoder for the Porter.
The QSI decoder on DC is an obvious pain without a battery, so switching to DCC is a must.
Thank You for your time.
Ralph
| | | |
| rwbrashear
1st Class Member
Perkasie, PA
Foreman
Posts:111
Send Message
| | 08/04/2008 10:08 AM |
| Hi Ralph-
You wrote:
Would you recomemnd one like Tony's DCC reader? Is there a cheaper option?
The Tony's meter works fine and it is my personal preference. However, there are other methods of reading track voltage without buying a scope.
Digitrax gives instructions for reading the DCC voltage between each rail and the ground.
http://www.digitrax.com/appnote_trvolt.php
NCE also provides a DCC meter schematic. Here is a discussion, including a link to the meter schematic:
http://jdb.psu.edu/nmra/dcc-voltmeter.html
Best regards,
Bob | | | |
| Road Foreman
1st Class Member
Ashland, Kansas
Foreman
Posts:237
Send Message
| | 08/04/2008 11:28 AM |
| Ralph,
The DB200 will be OK.. In large scale you will want a power supply that can supply 8 amps @ 24 volts DC or 18 volts AC.. You can contact Bachmann about a sound decoder for the Shay or install a QSI Magnum.. For the Consolidation I would use the DG 583S with the Soundtraxx or install a QSI Magnum.. I have a old Porter & the stall current was less than 1 amp.. For the Porter I would use a HO decoder that has about 1.5 amp constant & 2 amps stall current..
BulletBob | |
Bob Burton | |
|
| | You are not authorized to post a reply. |
|
| |
ActiveForums 3.7 |
|