Greetings,

 

I had to take my S-12 apart to get the rear driver repaired.  I have it back now and installed on the loco.

 

My problem is this.  I forgot exactly how the little screws, washers and such are supposed to go bak together.

 

I think the two pieces of drive rod are connected with a silver hex bolt and the tiny brass washer between the two pieces.  Could someone please verify this for me.  Any pictures or details would be greatly appreciated.

 

Thanks

I spoke to Cliff earlier.  He is sending me a few replacement screws, however there isn't an exploded drawing available.

I have spent some more time looking at it.  The only concern I have at the moment is where do the two small bushings go.

Kent,

 I just looked at mine and yes if you are talking about the connecting rod between #2 and #3 driver they are held together by the hex head screw, as for the washer I can not see one without taking it apart. Make sure to use loctite on the screws or they will come out!