Looking for a 4 wire jumper cable > Forums

Subject: Looking for a 4 wire jumper cable

Forum Sponsored By: PCGRS

Email me when someone replies to this thread.

You are not authorized to post a reply.

Author

Messages

GN_Rocky

1st Class Member

Brakeman
Posts:79

11/27/2008 10:32 PM
Don't know if anyone has one of these, but I need to find a 4 wire jumper cable with the flat cable ends that will allow me to connect my Aristo motor block to the circuit board in my 2-10-2. I'd like to do it right and not "Rig" up something. needs to be 6-8 inches long due to the motor being in the front end of the mallet drive and I am using a pacific type frame. There will be no room in the boiler because it will have 2 pacific weights in it filling it up. I may be able to use a plug wit hthe wire on it and solder the other plug on the other end. Anyone have one of these cables ??? It could be longer than 8 inches too as I could coil the excess in the bottom of the smoke box. Thanks !!! Rocky

Stan Cedarleaf User is Offline

1st Class Member
Dewey, AZ