Wood or steel cab? > Forums > myLargescale.com

Subject: Wood or steel cab?

Forum Sponsored By: Ozark Miniatures

Email me when someone replies to this thread.

You are not authorized to post a reply.

Author

Messages

Ray Dunakin User is Offline

Sandy Eggo
Foreman

Foreman
Posts:224

Send Message

10/26/2008 12:32 PM
I'm planning on kitbashing some locos, and I'm trying to decide whether wood or steel cabs would be appropriate. So I have a few questions: When did steel cabs come into common use? How late were wooden cabs still being built on new locos? In a lot of old black and white photos it's hard to tell whether the cab is wood or steel. Is there any way to be sure? I'm modeling relatively small locos, not big mainline stuff, if that makes any difference.

www.raydunakin.com

DKRickman

1st Class Member
Salisbury, NC
Foreman

Foreman
Posts:376

10/26/2008 2:03 PM
Ray, First of all, I'll assume you're talking about US practice. It seems to me that steel cabs became common somewhere around 1890 or so. Wooden cabs could be ordered as late as the last steam engine built, though it would have been a rarity. Older locomotives could have kept their wooden cabs for many years, especially if you're talking about a narrow gauge operation. As far as telling the difference, if you can see the front of the cab, look at the shape. Most steel cabs I've seen have a smooth curve from the sides all the way through to the roof, whereas wooden cabs usually had obviously separate sides and roofs. From the side, you may also be able to see that division, but also look below the windows. Most wooden cabs would have been built with some sort of frame and panel design, which shows up pretty easily. Steel cabs were usually a solid sheet. In the end, mix and match, use what you like, and justify it however you like. It's hard (but not impossible) to justify a steel cab in 1860, but wooden cabs in the 1940s were not uncommon.

Kenneth Rickman - krickman1@carolina.rr.com Salisbury, NC If at first you don't succeed, use a bigger hammer!

rkapuaala

1st Class Member
OZ

Conductor
Posts:746

10/26/2008 3:52 PM
Does it depend on the RailRoad? I notice that OR&L steel cabs started around 1902.

I keep forgetting we're not in Kansas!

You are not authorized to post a reply.

Forums > Forums > Model Making > Wood or steel cab?