Wholesaletrains.com

 | 

Wednesday, January 07, 2009   You Are Here: Forums

 


Subject: Aristo Craft Walk around throttle antenna problem
Forum sponsored by PCGRS
Forum Sponsored By: PCGRS
 
Prev Next
You are not authorized to post a reply.
AuthorMessages
lstc-superintendentUser is Offline

Passenger
Passenger
Posts:6

Send Message
07/29/2008 6:45 PM  
I had a dead spot behind the house in signal from my A-C walkaround throttle in the back yard. I have solved the problem by hooking up the antenna wire from the Aristo Craft receiver to one of the unused power wires running underground from my sunroom to the backyard. I have several pairs of bell wire running through a half inch plastic pipe. These wires run from my inside my sunroom to the garden railroad area of the backyard. I have run this plastic pipe along side most of the track with a power feed coming out of the pipe about every 25 feet. This helps to ensure a good power feed to the layout. I have had this system in place for several years but just got around to connecting the power lines to the track. Before this I just used a pair on clip-ons at one location. I would recomend anyone using this method of power supply to use a 3/4" pipe rather than 1/2" as it would make it a little easier to add wires through the pipe if needed.
Thanks,
Mike McILwaine
TorbyUser is Offline
1st Class Member
North Chicago 'burbs.
Engineer
Engineer
Posts:1907

Send Message
07/30/2008 6:01 AM  
Rarely does it hurt to add length to a receiver antenna;)

One king held the frankincense,
One king held the myrrh,
One king held the purest gold,
One King held the hope of the world.
-- Point of Grace
You are not authorized to post a reply.
Forums > Forums > Public Forum > Aristo Craft Walk around throttle antenna problem



ActiveForums 3.7
Terms Of Use | Copyright 2007 by myLargescale.com/Model Railroads Online, LLC  | Privacy Statement