Thursday, September 02, 2010  | Forums

Bachmann K-27 battery R/C version # 4
Last Post 18 Oct 2008 11:06 PM byTonyWalsham. 0 Replies.
AddThis - Bookmarking and Sharing ButtonPrinter Friendly
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
AuthorMessages
TonyWalshamUser is Offline
1st Class Member
Foreman
Foreman
Send Message
Posts:1295
TonyWalsham

--
18 Oct 2008 11:06 PM  

I have just finished another Bachmann K-27 battery R/C + Phoenix P5 sound install.

This was done slightly differently again.
I fabricated a small sheet of 1.5 mm thick styrene to mount the ON-OFF switch, Charge Jack, Phoenix volume control and programming jack.

Here are the dimensions I used:


The plate is mounted under the front lip below the front of the coal load and avoids drilling any holes in the tender shell or chassis.


I used the RCS BIK-U3+VC which has a built in volume control switch.  However, you could use any sort of switch you wished.
 

Best wishes,
Tony Walsham
Remote Control Systems.  www.rcs-rc.com/

Beltrol Radio Control.  www.beltrol-rc.com/



The primary problems of the planet arise not from the poor, for whom education is the answer. They arise from the well educated - for whom self interest is the problem.  William Sloane Coffin.

You are not authorized to post a reply.

Active Forums 4.2
Top of Page | Terms of Use | Copyright 2009 by myLargescale.com/Model Railroads Online, LLC | Privacy | Contact Us